WEBVTT

00:00.000 --> 00:04.767
I will share with you a method for welding tin

00:04.767 --> 00:14.041
Welding a tin safety sleeve results in melting plastic!

00:14.041 --> 00:20.939
Put on safety glasses!

00:20.041 --> 00:38.941
It is enough to remove the chrome part and to expose the core of the metal (not to press too much)

00:38.941 --> 00:47.704
Notice the result, the shiny party on which slipped the tin is no more than a memory!

00:47.704 --> 00:56.060
Thoroughly clean the tip and 'wet' it with a little solder

00:56.060 --> 01:07.385
Tinning will make it possible to increase the surface in contact with the sleeve

01:07.385 --> 01:14.647
To better diffuse heat! But not too much

01:14.647 --> 01:31.334
Unless you have 3 hands, proceed in steps

01:31.334 --> 01:35.602
I put a little solder on the plug

01:35.602 --> 01:41.541
To further reduce the risk of squatting the socket ...

01:41.541 --> 01:51.796
Tip: Insert a safety plug before welding

01:51.796 --> 02:01.281
Otherwise, the concentricity will be damaged if it is heated too long

02:01.281 --> 02:11.708
Here, too much tin to weld does not need, just cover the scraped part

02:11.708 --> 02:17.311
The weld must not melt on the iron; it is not the weld that is welded!

02:17.311 --> 02:24.014
It is only for the transmission that the iron is tapped, after the wire has to melt on the sleeve

02:24.014 --> 02:33.077
Foul of 'soudure sèche'

02:33.077 --> 02:38.316
Twist the strand if stranded

02:38.316 --> 02:45.855
Here again the conductor to be welded is prepared by tinning

02:45.855 --> 02:52.791
Without addition of wire, otherwise it will be necessary to release a hand to keep the sleeve

02:52.791 --> 03:02.690
Take care to heat the thickest, most difficult to warm

03:02.690 --> 03:10.341
Allow to cool especially for the plastic which is liable to deform

03:10.341 --> 03:22.121
By insisting too much it is the whole metal part which is disengaged!

03:22.121 --> 03:35.616
Perfect welding and positioning!